Nokia Lumia 925 Lcd screen and touchscreen View larger

Lcd screen and touch glass assembled for Nokia Lumia 925

PMFR4971

New

Lcd screen and touch glass assembled Nokia Lumia 925 - Contour gray.

More details

In stock

27,19 € tax incl.

Videos

Data sheet

Pre-gluing of the glass: No: Not systematic: It is necessary either to recover the old one, or to buy adhesive "quarter rolls 2mm"
For what type of breakdown? Typical LCD or touch-sensitive problems: Display fault, black screen, image with faults. Touch problem, touch that does not respond or wrong. Screen that stays fixed on the logo at startup. Impossible to type or type anything.

More info

Lcd screen and touch glass assembled in spare parts to repair my Nokia Lumia 925 - Contour gray.

Procedure :

1 / protect the screen of the 925 lumia, remove cards SIM SD and other accessories.

2 / remove the back cover, help you if necessary a plunger, a lever or plectrum.

3 / remove the battery connector and secure it with tape.p >

4 / remove the 3 screws Torx T6 (silver color)

5 / remove the silver plate

6 / disconnect the connector close to the camera < /.p >

7 / disconnect the connector from the side buttons < /.p >

8. Disconnect the connector of the screen (big black, the other side of the camera 6 /)

9 / disconnect the main connector (opposite the battery compared to a camera)

10 / disconnect the connector of the camera.p >

11 / disconnect the coaxial cable connector antenna (do not shoot, make a quarter turn), the other side of this cable must be connected!

12 / unscrew the two screws T4 from the top of the phone < /p>

13 / remove the antenna MIMO, small black plate up right as you hold your phone as if you were taking you picture. This small sheet of 1 cm to 0.5 has a small hole. < /p >

14 / remove the entire motherboard, starting with the side of the antenna MIMO (13 /), then the other angle of the top of the phone, then the rest.

< p>15 / or not you can remove the Camera.p >

16 / Repull the black plate on top of the phone, attention to the connector only goes inside

17 / remove the camera front

18 / remove the jack connector audio connectors attention

19 / unscrew the two screws down T4

20 / release the buttons. < /p >

21 / remove the block speaker low ringtone (black block under the battery)

22 / if need separate this block in two partes (Hp and antenna)

23 / free the other side of the coaxial antenna (black wire) warning, be careful, the cable pulls itself by its metal parts.

24 / remove the big water of the bottom (below the battery)

25 / the battery by lever

26 / if necessary, the vibrator is placed just above the battery under a small plate silver.

Reverse the procedure to reassemble the phone.

To remove the glued part, heat the glue to soften.

To unplug a connector, always act by lever and not by pulling on the cable. < /p >

Those products may also interest you


Accessories

Delivery Date

Order before 14 h

for delivery between 03/05 and the 06/05/24

Approximate date using Suivi GRATUIT moreInfo
Close